- Knowledge Base
- Products
- A01: Sumo
-
Products
- CalcPad
- A01: Sumo
- A03: Frame
- D01: Padds
- S01: Strut
- S02: Combine
- S11: Base Plate
- C01: Continuous Beam
- C04: Rectangular Slab
- C13: General Column
- C15: Pad Footing
- T01: Timber Beam
- G01: Prosec
- G04: Sections
- D02: Probar 2D for AutoCAD®
- D05: Pronet
- D04: Prodesk
- D05: Prodesk Steel
- D22: Probar 2D for BricsCAD®
-
Licensing
-
Web Streaming
Combinations only
This setting can be enabled to analyse combinations only. Individual load cases are then not solved.
To analyse a model for combination loads only, the following steps can be adopted in Sumo:
- Under the Analysis tab, click on Settings
- Go to General, tick the Combinations only checkbox, and click OK
- After a successful analysis, go to the Results workspace
- Only results from combinations will be shown