- Knowledge Base
- Products
- D01: Padds
-
Products
- CalcPad
- A01: Sumo
- A03: Frame
- D01: Padds
- S01: Strut
- S02: Combine
- S11: Base Plate
- C01: Continuous Beam
- C04: Rectangular Slab
- C13: General Column
- C15: Pad Footing
- T01: Timber Beam
- G01: Prosec
- G04: Sections
- D02: Probar 2D for AutoCAD®
- D05: Pronet
- D04: Prodesk
- D05: Prodesk Steel
- D22: Probar 2D for BricsCAD®
-
Licensing
-
Web Streaming
Magnetic cursor
With the magnetic cursor enabled, the cursor will snap to close points for accurate modelling.
Cursor snaps can be enabled to force the cursor to precise point locations. Snaps can
be permanently enabled or disabled by toggling the Magnetic Cursor Mode on or off.
To turn the magnetic cursor on, navigate to the status bar, click on Modes > Magnetic Cursor.
If the magnetic cursor is already selected, it will be highlighted.